Owner's Manual

- - ----- ...-- -- - - ------ -----------------
Certifications
Meets essential requirements of the following European Directives:
• WEEE Directive 2002/96/EC, as amended by 2008/34/ EC
• RoHS Directive 2011 /65/ EU
Note: Please follow your regional recycling scheme for batteries and electronic
waste
This product meets the Essential Requirements of all relevant European
directives and is eligible for CE marking.
Hereby, Shure Incorporated declares that the radio equipment is in com-
pliance with Directive 2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet address: http://www.shure.
com/europe/compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Sir. 12
75031 Eppingen, Germany
Phone: [phone] O
Fax: [phone]
Email: [e-mail]
P3R
Approved under the Declaration of Conformity (DoC) provision of FCC
Part 15.
Complies with requirements set out in RSS-GEN.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/
NMB-3(B)
This device complies with Industry Canada licence-exempt RSS stan-
dard(s). Operation of this device is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired opera-
tion of the device.
Le present appareil est conforme aux CNR d'lndustrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisee aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouil-
lage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioelec-
trique subi, meme si le brouillage est susceptible d'en compromettre le
fonctionnement.
P3T
Certified under FCC Part 74.
Certified by IC in Canada under RSS-123 and RSS-102.
IC: 616A-P3TA, 616A-P3TB, 616A-P3TD.
FCC:DD4P3TA , DD4P3TB, DD4P3TD, DD4P3TT.
Certified by IC in Canada under RSS-102 and RSS-210.
IC: 616A-P3TT.
This device operates on a no-protection no -interference basis. Should
the user seek to obtain protection from other radio services operating in
the same TV bands, a radio licence is required. Please consult Industry
Canada's document CPC-2-1-28, Optional Licensing for Low-Power Radio
Apparatus in the TV Bands, for details.
Ce dispositif fonctionne selon un regime de non-brouillage et de non-pro-
tection. Si l'utilisateur devait chercher a obtenir une certaine protection
centre d'autres services radio fonctionnant dans les memes bandes de
television, une licence radio serait requise. Pour en savoir plus, veuillez
consulter le document CPC-2-1-28 d'lndustrie Canada intitule, Delivrance
de licences sur une base volontaire pour les appareils radio de faible puis-
sance exempts de licence et exploites dans les bandes de television.
The antenna(s) must be installed such that a minimum separation dis-
tance of 20 cm is maintained between the radiator (antenna) and all per-
sons at all times.
La ou les antennes doivent etre installees de telle fac;:on qu'une distance
de separation minimum de 20 cm soil maintenue entre le radiateur (an-
tenne) et toute personne a tout moment.
Important Product Information
LICENSING INFORMATION
Licensing: A ministerial license to operate this equipment may be required
in certain areas. Consult your national authority for possible requirements.
Changes or modifications not expressly approved by Shure Incorporated
could void your authority to operate the equipment. Licensing of Shure
wireless microphone equipment is the user's responsibility, and licens-
ability depends on the user's classification and application, and on the
selected frequency. Shure strongly urges the user to contact the appropri-
ate telecommunications authority concerning proper licensing, and before
choosing and ordering frequencies.
Information to the user
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radi-
ate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communi-
cations. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technici_an for help.
Industry Canada ICES-003 Compliance Label: CAN ICES-3 (B)/
NMB-3(B)
Note: EMC conformance testing is based on the use of supplied and rec-
ommended cable types. The use of other cable types may degrade EMC
performance.
Changes or modifications not expressly approved by the manufac-
turer could void the user's authority to operate the equipment.
Please follow your regional recycling scheme for batteries, packaging, and
electronic waste.
Australia Warning for Wireless
This device operates under an ACMA class licence and must comply with
all the conditions of that licence including operating frequencies. Before
31 December 2014, this device will comply if it is operated in the 520-820
MHz frequency band. WARNING: After 31 December 2014, in order to
comply, this device must not be operated in the 694-820 MHz band.
14