Owner's Manual
Table Of Contents
- PSM300 User Guide
- PSM300 Stereo Personal Monitor System Online User Guide
- Table of Contents
- PSM300Stereo Personal Monitor System
- Important Product Information
- PSM®300
- PSM®300
- Hardware
- System Applications
- System Setup and Configuration
- Operation
- Troubleshooting
- Specifications
- RF Carrier Range
- Compatible Frequencies
- Tuning Bandwidth
- Operating Range
- Audio Frequency Response
- Signal-To-Noise Ratio
- Total Harmonic Distortion
- Companding
- Spurious Rejection
- Latency
- Frequency Stability
- MPX Pilot Tone
- Modulation
- Operating Temperature
- RF Output Power
- RF Output Impedance
- Net Weight
- Dimensions
- Power Requirement
- Audio Input
- Connector Type
- Polarity
- Configuration
- Impedance
- Nominal Input Level
- Maximum Input Level
- Pin Assignments
- Phantom Power Protection
- Audio Output
- Connector Type
- Configuration
- Impedance
- Active RF Sensitivity
- Image Rejection
- Adjacent Channel Rejection
- Intermodulation Attenuation
- Blocking
- Audio Output Power
- Minimum Load Impedance
- Headphone Output
- Output Impedance
- Net Weight
- Dimensions
- Battery Life
- Frequency Range and Transmitter Output Power
- Optional Accessories and Replacement Parts
- Certifications
- PSM®300 Personal Monitor Wireless System Frequency Supplement
- PSM300 Personal Monitor System Product Info
- P3RA User Guide
- P3RA Professional Bodypack Receiver Safety Information
- SE215 Manual
- Rack Mount Hardware Kit Instruction Sheet
- AA Battery Insertion for Bodybacks
- A Quick Guide to Personal Monitor Systems
- Warranty
- Safety Precautions
Shure Incorporated
16/36
1.
2.
3.
4.
Note: Always use both straddle bars when mounting two units.
Power, Audio, and RF Connections
Use the power adapter to connect the P3T to an AC power source.
Install 2 AA batteries in the bodypack receiver.
Attach the antenna to the BNC antenna connector on the P3T rear panel.
Connect the mixer or audio source to the P3T audio inputs using ¼ inch balanced cables.
Important: When connecting to only one transmitter input, use the LEFT/CH1 input. Set the transmitter to MONO to hear audio on both channels of
the receiver.