Owner's Manual
Table Of Contents
- PSM300 User Guide
- PSM300 Stereo Personal Monitor System Online User Guide
- Table of Contents
- PSM300Stereo Personal Monitor System
- Important Product Information
- PSM®300
- PSM®300
- Hardware
- System Applications
- System Setup and Configuration
- Operation
- Troubleshooting
- Specifications
- RF Carrier Range
- Compatible Frequencies
- Tuning Bandwidth
- Operating Range
- Audio Frequency Response
- Signal-To-Noise Ratio
- Total Harmonic Distortion
- Companding
- Spurious Rejection
- Latency
- Frequency Stability
- MPX Pilot Tone
- Modulation
- Operating Temperature
- RF Output Power
- RF Output Impedance
- Net Weight
- Dimensions
- Power Requirement
- Audio Input
- Connector Type
- Polarity
- Configuration
- Impedance
- Nominal Input Level
- Maximum Input Level
- Pin Assignments
- Phantom Power Protection
- Audio Output
- Connector Type
- Configuration
- Impedance
- Active RF Sensitivity
- Image Rejection
- Adjacent Channel Rejection
- Intermodulation Attenuation
- Blocking
- Audio Output Power
- Minimum Load Impedance
- Headphone Output
- Output Impedance
- Net Weight
- Dimensions
- Battery Life
- Frequency Range and Transmitter Output Power
- Optional Accessories and Replacement Parts
- Certifications
- PSM®300 Personal Monitor Wireless System Frequency Supplement
- PSM300 Personal Monitor System Product Info
- P3RA User Guide
- P3RA Professional Bodypack Receiver Safety Information
- SE215 Manual
- Rack Mount Hardware Kit Instruction Sheet
- AA Battery Insertion for Bodybacks
- A Quick Guide to Personal Monitor Systems
- Warranty
- Safety Precautions
Shure Incorporated
25/36
Problem Solution
Turning the Mix
Mode knob does
not affect the
sound
The StereoMX/Mono switch on the rear panel of the P3T may be switched to mono. For the Mix
Mode knob to work, the transmitter must be set to Stereo-MX.
Verify that the signals going from the mixer to the transmitter are not identical
Check that the bodypack is set to MixMode
Low audio output
at the receiver
Check headphone connection and volume level
If only sending a single channel into the P3T transmitter, check it the MixMode knob isn't turned to
wards a silent channel. If using one channel, set the P3T transmitter to mono mode.
Audio or RF drops
out
Perform a scan to ensure the receiver is on a clear (available) frequency
Make sure there is a line-of-sight path between the transmitter antenna and the bodypack receivers
Verify that other wireless devices that are being monitored, such as wireless microphones, are not
experiencing RF dropouts
If using an antenna other than the one included with the system, make sure it is designed to operate
in the correct frequency range
IR sync failure Verify distance between receiver and transmitter is between 6-11 cm
Specifications
RF Carrier Range
488-937.5 MHz
varies by region
Compatible Frequencies
Per band
up to 15
Tuning Bandwidth
24 MHz Maximum
Note: varies by region
Operating Range
environment dependent
90 m (300 ft)
Audio Frequency Response
38 Hz –15 kHz
Signal-To-Noise Ratio
A-Weighted
90 dB (typical)