Owner's Manual
Table Of Contents
- PSM300 User Guide
- PSM300 Stereo Personal Monitor System Online User Guide
- Table of Contents
- PSM300Stereo Personal Monitor System
- Important Product Information
- PSM®300
- PSM®300
- Hardware
- System Applications
- System Setup and Configuration
- Operation
- Troubleshooting
- Specifications
- RF Carrier Range
- Compatible Frequencies
- Tuning Bandwidth
- Operating Range
- Audio Frequency Response
- Signal-To-Noise Ratio
- Total Harmonic Distortion
- Companding
- Spurious Rejection
- Latency
- Frequency Stability
- MPX Pilot Tone
- Modulation
- Operating Temperature
- RF Output Power
- RF Output Impedance
- Net Weight
- Dimensions
- Power Requirement
- Audio Input
- Connector Type
- Polarity
- Configuration
- Impedance
- Nominal Input Level
- Maximum Input Level
- Pin Assignments
- Phantom Power Protection
- Audio Output
- Connector Type
- Configuration
- Impedance
- Active RF Sensitivity
- Image Rejection
- Adjacent Channel Rejection
- Intermodulation Attenuation
- Blocking
- Audio Output Power
- Minimum Load Impedance
- Headphone Output
- Output Impedance
- Net Weight
- Dimensions
- Battery Life
- Frequency Range and Transmitter Output Power
- Optional Accessories and Replacement Parts
- Certifications
- PSM®300 Personal Monitor Wireless System Frequency Supplement
- PSM300 Personal Monitor System Product Info
- P3RA User Guide
- P3RA Professional Bodypack Receiver Safety Information
- SE215 Manual
- Rack Mount Hardware Kit Instruction Sheet
- AA Battery Insertion for Bodybacks
- A Quick Guide to Personal Monitor Systems
- Warranty
- Safety Precautions
Audio
Settings
MODE
EQ
STEREO:
Audio from channel 1 is heard on
the
left earphone; audio from
channel 2 is on
the
right earphone.
MIXMODE:
Both channels are heard on the left
and
right earphones.
The
blend
between mixes is adjustable.
Use the two-band shelving equalizer to boost either bass
or
treble frequencies
up
to +6dB in 2
dB
increments.
LOW
BOOST:
Boosts frequencies below 100 Hz
HIGH
BOOST:
Boosts frequencies above 1 O kHz
OFF:
No
EQ
(flat)
VLIMIT
(Maximum Volume)
Set a value (-3 to
-21
dB, adjustable in 3 dB increments)
to
attenuate the
highest possible volume level. Turning the volume knob through its entire
range
of
motion still affects volume;
the
limit simply narrows the range
of
dB
adjustment.
Note:
The
VLIMIT
does not compress
the
audio.
BALMX/
BAL
ST
(Balance)
The behavior
of
the
balance control depends on which
mode
the
bodypack is
set to:
STEREO:
Adjusts
the
left/right balance
MIXMODE:
Adjusts the blend between channel 1 and channel 2
6
Utilities
CONTRAST
Customize the display screen contrast
by
selecting a setting between low and
high
LOCK
PANEL
Locks all controls except
the
volume knob to prevent accidental changes to
settings
Lock: Select
UTILITIES>
LOCK
PANEL
Unlock: Press
the
exit button and select
OFF
when
the
lock setting screen
appears. Press enter
to
confirm.
BATTERY
Displays remaining battery runtime (hours:minutes), temperature, status,
cycle count, health, and voltage
Note: Applies to
SB900A
battery only
RESTORE
Restores bodypack
to
factory default settings
AUTOOFF
Automatically turns off
the
bodypack
after a selectable amount
of
time (5, 30,
or
60 min.) while it is in power-save mode
or
when connected to a charger
with the power on.
To
restore power to
the
bodypack, the power switch must
be turned
off
and then
on
again.
Note: SB900 batteries charge fastest when the bodypack is off
RF
Settings
The RADIO menu contains selectable
GROUP
and
CHANNEL
settings, which are used
to manually synchronize
the
receiver with
the
transmitter.
The
frequency and band are displayed
below
the
group and channel settings for
reference.