Owner's Manual
Table Of Contents
- PSM300 User Guide
- PSM300 Stereo Personal Monitor System Online User Guide
- Table of Contents
- PSM300Stereo Personal Monitor System
- Important Product Information
- PSM®300
- PSM®300
- Hardware
- System Applications
- System Setup and Configuration
- Operation
- Troubleshooting
- Specifications
- RF Carrier Range
- Compatible Frequencies
- Tuning Bandwidth
- Operating Range
- Audio Frequency Response
- Signal-To-Noise Ratio
- Total Harmonic Distortion
- Companding
- Spurious Rejection
- Latency
- Frequency Stability
- MPX Pilot Tone
- Modulation
- Operating Temperature
- RF Output Power
- RF Output Impedance
- Net Weight
- Dimensions
- Power Requirement
- Audio Input
- Connector Type
- Polarity
- Configuration
- Impedance
- Nominal Input Level
- Maximum Input Level
- Pin Assignments
- Phantom Power Protection
- Audio Output
- Connector Type
- Configuration
- Impedance
- Active RF Sensitivity
- Image Rejection
- Adjacent Channel Rejection
- Intermodulation Attenuation
- Blocking
- Audio Output Power
- Minimum Load Impedance
- Headphone Output
- Output Impedance
- Net Weight
- Dimensions
- Battery Life
- Frequency Range and Transmitter Output Power
- Optional Accessories and Replacement Parts
- Certifications
- PSM®300 Personal Monitor Wireless System Frequency Supplement
- PSM300 Personal Monitor System Product Info
- P3RA User Guide
- P3RA Professional Bodypack Receiver Safety Information
- SE215 Manual
- Rack Mount Hardware Kit Instruction Sheet
- AA Battery Insertion for Bodybacks
- A Quick Guide to Personal Monitor Systems
- Warranty
- Safety Precautions
--------
-----
--------
MixMode and Stereo Monitoring
--------------------------------
The bodypack can operate in either of the following listening modes:
Stereo (default)
To operate in stereo mode, enter the menu and select AUDIO>
MODE
>STEREO
.
In stereo mode, audio from channel 1 is heard on the left earphone, while audio from
channel 2 is heard on the right earphone. Listening in stereo increases clarity and
separation between the sources on each channel.
Adjusting Balance
To adjust the left/right balance, select AUDIO>
BAL
ST.
Use the
•"
buttons to change
the setting.
MixMode
To operate in MixMode, enter the menu and select AUDIO>
MODE
>
MIXMODE.
Left (Channel 1)
Right (Channel 2)
In MixMode, the blend between two monitoring mixes (an instrumental mix and a vocal mix, for example) is adjustable. The signal is mono, which means each mix is
heard through both the left and right earphones.
Adjusting mix blend
To
adjust the blend between channel 1 and channel 2, enter
the
menu and select AUDIO>
BALMX.
Use the arrow
buttons(••)
to make adjustments.
In this scenario, an instrumental mix is on channel 1 (left) and a vocal mix is on channel 2 (right):
OMIXMODE
10L
L
1
II
I
IR
Instruments Vocals
To hear more of channel one (instruments),
shift the balance towards the left.
Instruments
Vocals
Balance and Mix Adjustments from the Home Screen
OMIXMODE
10R
L
1
111
1
R
Instruments
Vocals
To hear more
of
channel two (vocals), shift
the bal~nce towards the right.
Vocals
Instruments
To make quick adjustments to the stereo balance
or
MixMode blend, use the arrow buttons
(••)while
in the home screen. If necessary, use the lock feature to prevent
any accidental adjustments.
7