Owner's Manual
Table Of Contents
- PSM300 User Guide
- PSM300 Stereo Personal Monitor System Online User Guide
- Table of Contents
- PSM300Stereo Personal Monitor System
- Important Product Information
- PSM®300
- PSM®300
- Hardware
- System Applications
- System Setup and Configuration
- Operation
- Troubleshooting
- Specifications
- RF Carrier Range
- Compatible Frequencies
- Tuning Bandwidth
- Operating Range
- Audio Frequency Response
- Signal-To-Noise Ratio
- Total Harmonic Distortion
- Companding
- Spurious Rejection
- Latency
- Frequency Stability
- MPX Pilot Tone
- Modulation
- Operating Temperature
- RF Output Power
- RF Output Impedance
- Net Weight
- Dimensions
- Power Requirement
- Audio Input
- Connector Type
- Polarity
- Configuration
- Impedance
- Nominal Input Level
- Maximum Input Level
- Pin Assignments
- Phantom Power Protection
- Audio Output
- Connector Type
- Configuration
- Impedance
- Active RF Sensitivity
- Image Rejection
- Adjacent Channel Rejection
- Intermodulation Attenuation
- Blocking
- Audio Output Power
- Minimum Load Impedance
- Headphone Output
- Output Impedance
- Net Weight
- Dimensions
- Battery Life
- Frequency Range and Transmitter Output Power
- Optional Accessories and Replacement Parts
- Certifications
- PSM®300 Personal Monitor Wireless System Frequency Supplement
- PSM300 Personal Monitor System Product Info
- P3RA User Guide
- P3RA Professional Bodypack Receiver Safety Information
- SE215 Manual
- Rack Mount Hardware Kit Instruction Sheet
- AA Battery Insertion for Bodybacks
- A Quick Guide to Personal Monitor Systems
- Warranty
- Safety Precautions
Certifications
This product meets the Essential Requirements
of
all relevant European directives
and is eligible for CE marking.
Meets essential requirements
of
the following European Directives:
• Low Voltage Directive 2006/95/EC
Conforms to the relevant requirements
of
regulation (EC) No.278/2009, for low
voltage external power supplies.
Meets essential requirements
of
the following European Directives:
WEEE Directive 2002/96/EC, as amended by 2008/34/EC
RoHS Directive
2011
/65/EU
Note: Please follow your regional recycling scheme for batteries and electronic
waste
This prqduct meets the Essential Requirements
of
all relevant European directives
and is eligible for CE marking.
Hereby, Shure Incorporated declares that the radio equipment is in compliance
with Directive 2014/53/EU. The full text
of
the EU declaration
of
conformity
is available
at
the following internet address: http://www.shure.com/europe/
compliance
Authorized European representative:
Shure Europe GmbH
Headquarters Europe, Middle East & Africa
Department: EMEA Approval
Jakob-Dieffenbacher-Str.
12
75031 Eppingen, Germany
Phone: +49-7262-92
49
0
Fax: +49-7262-92 49
11
4
Email: EMEAsupport@shure.de
P3RA
Approved under the Declaration
of
Conformity (DoC) provision
of
FCC Part 15.
Complies with requirements set out in RSS-GEN.
Industry Canada ICES-003 Compliance Label:
CAN
ICES-3 (B)/NMB-3(8)
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation
of
this device is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, in-
cluding interference that may cause undesired operation
of
the
device.
Le present appareil est conforme aux CNR d'lndustrie Canada applicables aux
appareils radio exempts
de
licence. L'exploitation est autorisee
aux
deux condi-
tions suivantes : (1) l'appareil ne doit pas produire
de
brouillage, et (2) l'utilisateur
de
l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouil-
lage est susceptible d'en compromettre le fonctionnement.
10
Optional Accessories and Replacement
Parts
Shure Lithium-Ion Rechargeable Battery SB900A
AA battery adapter 65A15224
Dynamic MicroDriver earphones
SE112
Dynamic MicroDriver earphones SE215
High-definition MicroDriver earphones with tuned
SE315
bass port
High-definition earphones with dual MicroDrivers SE425
High-definition earphones with triple MicroDrivers SE535
High-definition earphones with quad MicroDrivers SE846
Power a SB900A-compatible bodypack with an AC
power supply instead
of
batteriesDC Power Insert
SBC-DC
(Battery Eliminator)
Single Rack Mount Kit
RPW503
Dual Rack Mount Kit RPW504