Model P4HW User Guide P4HW Hardwired Personal Monitor ©2003, Shure Incorporated 27D8713 (Rev. 4) Patent Des. 442,938 Printed in U.S.A.
WARNING! USING THIS SYSTEM AT EXCESSIVE VOLUMES CAN CAUSE PERMANENT HEARING DAMAGE. USE AS LOW A VOLUME AS POSSIBLE. In order to use this system safely, avoid prolonged listening at excessive sound pressure levels. Please use the following guidelines established by the Occupational Safety Health Administration (OSHA) on maximum time exposure to sound pressure levels before hearing damage occurs.
ENGLISH Thank you for choosing the P4HW Hardwired Personal Monitor bodypack.
Operation BATTERY INSTALLATION 1. Open the battery door by pushing down and sliding towards cable. 2. Insert a fresh 9 V alkaline battery with the +/– terminals properly positioned (see Figure 1). 3. Close the battery door. NOTE: If battery compartment door will not close, the battery is not properly inserted. FIGURE 1 CONNECTING TO MIXER AND CHECKING SIGNAL 1. Connect the “Y” cable of the bodypack to a line level audio source. 2. Turn the ON/OFF/VOLUME knob clockwise past click (ON). 3.
READING THE LCD SCREEN The LCD screen displays the status of each function, as follows: 1. Input Level Meter: 3-segment input level meter displays level of incoming signal. Always check for clipping prior to inserting earphones into ears. Signal present Nominal –6 dB from clip 2. Battery Life Meter: Indicates the amount of voltage left in the battery. If no indicators are present, change the battery as soon as possible. HIGH: 6-8 hours of operation. MEDIUM: 2-6 hours of operation.
USING THE BODYPACK FEATURES 1. Push either the SCROLL or SELECT button to activate the LCD screen. 2. Push and hold the SCROLL button until the desired function (0/–15, MIX, EQ, or LIM) is underscored. 3. Push the SELECT button to toggle the function ON or OFF. A function is ON when a dot appears to the right of the function symbol. 4. Push the SCROLL button to confirm the change. LOCKING THE DISPLAY 1. Adjust all functions to desired settings. 2.
MONO, STEREO AND MIXMODE CONTROL The bodypack provides simple configuration of a monitor mix and enables the user to customize an individual mix in a multiple mix environment. Three monitoring modes are available - mono, stereo, and MixMode. Mono: The bodypack receives one signal from the mixer and sends that signal to both earphones. For mono signals, use MixMode (MIX ON). Stereo: The bodypack receives two signals (L and R) from the mixer and sends the signals to the left and right earphones, respectively.
Specifications Frequency Response 20 to 20,000 Hz Total Harmonic Distortion < .1% (measured at –10 dBu out) Channel Separation 35 dB (minimum) Signal-to-noise ratio 85 dB (minimum) Maximum Output Level +5 dBu at 1% THD Maximum Input Level +7 dBu, input pad OFF +22 dBu, input pad ON Actual Input Impedance > 40 kW Audio Output Connector 3.
SHURE Incorporated Web Address: http://www.shure.com 5800 W. Touhy Avenue, Niles, IL 60714-4608, U.S.A.