Quick start Guide

Shure Incorporated
28/60
•
•
1.
2.
3.
•
•
•
1.
2.
3.
4.
Radio Frequency (RF) Settings
Setting the Transmitter RF Power
The transmitter offers two RF power settings which determine the transmitter range.
Lo = 1 mW
Hi = 10 mW
Use the Lo setting when the transmitter and receiver are in close proximity.
Navigate to the transmitter rf power menu.
Use the arrow buttons to select Hi or Lo.
Press enter to save.
Shure AXT600 Spectrum Manager Compatibility
QLX-D receivers are compatible with the Axient AXT600 Spectrum Manager. Networked receivers will appear in the
device inventory and frequencies from the Compatible Frequency List can be deployed and monitored by the
Spectrum Manager. For more information regarding the Spectrum Manager, see the Axient System Guide.
Using QLX-D with a Shure ULX-D System
Transmitters and receivers from QLX-D and ULX-D component groups can be paired to form audio channels.
To ensure functionality, use the following settings on receivers and transmitters:
Encryption set to Off
High Density Mode set to Off (ULX-D receiver)
Manually tune the receiver and transmitter to the same frequency. IR sync between QLX-D and ULX-D
components is not supported.
To create an audio channel, manually set the receiver frequency to match the frequency of the transmitter.
If using ULXD6 or ULXD8 transmitters with a QLX-D receiver, you can only make changes to transmitter presets
using Wireless Workbench.
Open receiver properties in WWB.
Make changes to transmitter presets and click Apply. The new settings will be sent to the QLX-D receiver.
On the receiver front panel, hold enter while pressing menu to enter the advanced menu.
Press menu to advance to Preset bn gn. The IR window will flash.