User manual

Shure Incorporated
5/11
WARNING:
• Do not use pliers or any other tools to tighten lock nut. DC power cable must be attached before charger unit is
installed.
• Do not plug in power supply unit until DC connection and charger are in place.
• After securing the charger, plug the power cable into a properly grounded outlet.
The charger has no power switch. When plugged in, the power LED illuminates. The charging LEDs illuminate af
ter batteries are inserted.
Power Save Mode
Use power save mode to charge batteries with the charger’s network functionality off.
1. Disconnect the power cable from the AC power outlet.
2. Press and hold storage while reconnecting to the AC power outlet.
3. When the charge status and error LEDs flash amber, release the button.
The charger remains in power save mode until you power off the charger.
Note: Transmitters docked with the power switch in the ON position will power on when fully charged. To avoid un
wanted audio and unnecessary battery drain, ensure all transmitters are switched OFF before charging.
Charging
To charge, place batteries into the charging bays with slotted sides down. The LEDs illuminate to indicate battery
status.
LED Indicators
Color State
Charge status LED red Charging
Charge status LED green Charging complete