User`s guide

ENGLISH

3. Connect one end of any standard guitar cable (two included) to the receiver AU-

DIO OUT connector (T3) or OUTPUT connector (T4G) and insert the other end

into the amplifier input.

4. Connect your guitar or bass to the transmitter input jack with any standard guitar

cable (two are supplied).

5. Turn the volume control on your guitar pickup all the way up.

6. Slide the recessed transmitter POWER ON/OFF switch to the ON position. The

green POWER ON light on the transmitter will turn on. The yellow RF light (T3)

or the DIVERSITY A/B lights (T4G) will also turn on.

7. Slide the transmitter MUTE/ON switch to the ON position.

8. Play your guitar or bass. Normal operation is indicated by:

•

Steady glow of yellow RF light (T3) or DIVERSITY A/B lights (T4G).

•

Flickering of the red PEAK light (T3) or AUDIO PEAK light (T4G) when loud

sounds are transmitted

NOTE: If the red PEAK light on the receiver does not flicker occasionally, refer to

the

Audio Gain Adjustment

paragraph. Then, if the system is still not operating

properly, consult the

Troubleshooting

table.

9. When the performance is over, slide the recessed transmitter POWER ON/OFF

switch to the OFF position to conserve battery power.