User`s guide

ENGLISH

OPERATING THE VOCAL ARTIST SYSTEM

1. Refer to Figure 9. Plug one end of the ac power adapter into the DC INPUT connec-

tor in back of the receiver, and plug the other end into an ac power source (use PS20

for 105–125 Vac, 60 Hz power; use PS20E for 230 Vac, 50 Hz power). The green

POWER light on the receiver will glow.

2. Connect one end of an audio cable to the receiver AUDIO OUT connector (T3), or

the OUTPUT or BALANCED LOW Z connector (T4V). Connect the other end of

the cable to the mixer input.

3. Slide the transmitter POWER ON/OFF switch to the ON position. The green

transmitter POWER ON light will glow. The yellow RF light (T3) or the DIVERSITY

A/B lights (T4V) will also glow.

4. Slide the MIC ON/OFF switch to the ON position to turn the microphone on.

5. Sing into the microphone. Normal operation is indicated by:

•

Steady glow of the yellow RF light ( T3) or DIVERSITY A/B lights (T4V).

•

Flickering of the red PEAK light (T3) or AUDIO PEAK light (T4V) when loud

sounds are transmitted.

NOTE: If the red PEAK light on the receiver does not flicker occasionally, the

transmitter gain may need to be increased. Refer to the

T2 Audio Gain Adjust-

ment

paragraph. Then, If the system is still not operating properly, consult the

Troubleshooting

table.

6. When the performance is over, slide the transmitter POWER ON/OFF switch to

the OFF position to conserve battery power.

FIGURE 9

90°

45°

T4V