User`s guide

ENGLISH
7
4
5
6
8
7
2
1
FIGURE 5
3
3
SQUELCH
12-18 VDC
DC INPUT
T4V
9
MIN MAX
2
1
SQUELCH
MIN
T4G
MAX
12-18 VDC
DC INPUT
T4 DIVERSITY RECEIVER FEATURES (FIGURE 5)
1. Power Input Connector: Connect the ac adapter to this jack and then plug into
an ac electrical outlet.
2. Squelch Control:This control is factory pre-set, and normally does not need further
adjustment. Refer to
Receiver Squelch Adjustment section for more information.
3. Telescoping Antennas: Receive signals from the transmitter. Make sure the an-
tennas are fully extended and point away from each other at a 45° angle from vertical.
4. Power On Indicator: This green light glows when the receiver is plugged into
an electrical outlet. It indicates that the receiver is on.
5. Diversity Signal Indicators: The yellow DIVERSITY A and B lights glow when RF
(radio frequency) signals are received from the T1 or T2 transmitter. When only one
light is glowing, the signal is being received on only one receiver section. When both
lights are glowing, theT4 is receiving signals on both receiver sections.
6. Audio Peak Indicator: This red light flickers when the audio signal approaches
the overload clipping level. It is affected by the transmitter gain control setting,
and the loudness of the guitar or bass (
Guitarist systems), the singer ( Vocal Artist
systems) or the talker ( Presenter systems) .
7. Volume Control: Rotate this knob to increase or decrease the volume of the re-
ceiver output. This control does not affect the AUDIO PEAK indicator.
8. Phone Jack Audio Output Connector (unbalanced): An unbalanced audio
cable with a
1
/
4
” phone plug can be used between this connector and your ampli-
fier input (optional for T4V receiver).
9. T4V RECEIVER: XLR Audio Output Connector (balanced): Plug an XLR-type
audio cable from this connector to the input of your audio mixer.