User's Manual

Shure Incorporated
13/17
•
•
•
Hirose Wiring for Sony Bodypacks
Notes:
When using TwinPlex mics with Sony Hirose 4pin bodypacks, Shure recommends purchasing Shure –MTQG versions
and not –NC versions. This facilitates an easier termination due to the lack of circuitry required in Shure 3wire/MTQG
TA4F products.
Due to the thin cable on TwinPlex and the large boot on Hirose connectors, heat shrink may be required to build up the ca
ble under the boot where the crimp connection is made and where the cable exits the boot
The TwinPlex Microdot (-MDOT) version can be used with 4-pin Hirose adapters from DPA (DPA part # DAD6008)
Series
Cable
Con
struc
tion
Electri
cal De
sign
Polari
ty
Replacement
Connector
For Use
With
Wiring
Line Art (From Solder
Side)
TH53-
LEMO
TH53-
NC
1.6mm
cable
with 2
con
duc
tors, 2
shield
wires
and
shield
2-Wire
(Com
mon
Source)
Nega
tive
with
re
spect
to
ground
Hirose 4-pin-
KMC-9BPD-4P
Sony Hirose
Bodypacks
(WRT)
Red wire: Audio/Bias:
Into resistor and ca
pacitor
1: 8.2k resistor
2: Jumper to 4
3: 1 uF capacitor (-)
4: Ground/shield-
jumper to 2
Split Shield to shell
Blue wire: not used
TH53-
MTQG
1.6mm
cable
with 2
con
duc
tors, 2
shield
wires
and
shield
3-Wire
(Source
Follow
er)
Posi
tive
with
re
spect
to
ground
Hirose 4-pin-
KMC-9BPD-4P
Sony Hirose
Bodypacks
(WRT)
1: Red wire (Bias)
2: Blue wire (Audio)
3: Jumper to 4
4: Ground/shield-
jumper to 3
Split Shield to shell