User's Manual

Shure Incorporated
29/51
1.
2.
1.
2.
3.
4.
Use this to turn on a transmitter without interfering with the RF spectrum.
Press and hold the exit button during power-on until RF MUTED is displayed. To un-mute, restart the transmitter.
Custom Groups
Use this feature to create up to six groups of manually selected frequencies that can be exported to networked receivers to
simplify system setup.
To create a custom group: UTILITES > ADVANCEDRF > CUSTOMGROUPS
Note: Use Wireless Workbench or Wireless Frequency Finder to select the best compatible frequencies. See www.shure.com for more information.
To export a custom group:
Go to UTILITES > ADVANCEDRF > CUSTOMGROUPS > EXPORT. The following screen will display.
Press the flashing ENTER button to export all custom groups to all receivers on the network.
Antenna Bias
Antenna ports A and B provide a DC bias to power active antennas. Set the DC power to off when using passive (nonpow
ered) antennas.
To turn bias off: DEVICEUTILITIES > ADVANCEDRF > ANTENNABIAS > OFF
Networking Receivers
The receiver uses an Ethernet connection to network with other components. For automatic network configuration, use a
DHCP enabled Ethernet switch such as the Shure AXT620. Use multiple Ethernet switches to extend the network for larger in
stallations.
Note: Note use only one DHCP server per network.
Automatic IP Addressing
Set the IP Mode to Automatic for all receivers: DEVICEUTILITIES > NETWORK > CTRLNETWORK
Manual IP Addressing
Connect the receivers to an Ethernet switch.
Set the IP Mode to Manual for all devices (DEVICEUTILITIES > NETWORK > CTRLNETWORK)
Set valid IP addresses for all devices.
Set the subnet mask to the same value for all devices.
Device ID
Set the receiver Device ID for easy identification within the network or in Wireless Workbench: DEVICEUTILITIES > NET
WORK > SHURECONTROL > Dev.ID
Use the control wheel to edit the device ID.
High Density Mode
High Density mode creates additional bandwidth for more channels in crowded RF environments. Frequency efficiency is opti
mized by running at 1 mW RF transmit power and narrowing the modulation bandwidth, allowing for the channel spacing to be
reduced from 350 kHz to 125 kHz. Transmitters can be positioned on adjacent channels with unsubstantial intermodulation dis
tortion (IMD).