Product Datasheet/Brochure
For more informaon on all products, please contact us at sales@us.shule.com or 626.820.9000
© 2018 Shule Computer Group, Inc. All rights reserved. Specicaons are subject to change without noce. Not responsible for any photographic or typographic errors.
Photos shown may vary from actual look. Intel, the Intel logo, and Intel Core are trademarks of Intel Corporaon or its subsidiaries in the US and/or other countries. ©Intel Corporaon
SPECIFICATIONS NOTES
CUBE PC
[1] ABOUT OVERCLOCKING
Please note there is a certain risk involved with overclocking, including adjusng the BIOS sengs or using third party overclocking tools. Overclocking may aect
your system stability or even cause damage of the components and devices in the system. Shule cannot be held responsible for possible damage caused by over-
clocking as it is done at your own risk and expense.
[2] SUPPORTS ADDITIONAL DISPLAYS
The integrated graphics already supports two addional displays via digital video outputs but with a discrete PCI-Express graphics card, this model can support more
displays. This funcon is based on the Switchable Graphics feature introduced with the 2nd generaon of Intel® Core™ processors. This can be enabled in the BIOS
setup ulity by pressing the “Delete” key aer powering on the PC and going to the “Advanced” tab to change the “Iniate Graphics Adapter” seng to “Switchable”.
[3] 4K ULTRA HD RESOLUTION
A 4K display with Ultra HD resoluon (3840 x 2160) should be connected via DisplayPort (supports a higher refresh rate of 60 Hz). Video playback performance
depends on the video format, bitrate, and processor used. Daily oce applicaons wouldn’t require the system to full load but playback requirements for smooth
4K video (2160p) requirements will be dierent (an Intel® Core™ i3 processor or higher and dual channel memory (2 or 4 modules) is recommended).
[4] HOW TO CONVERT DISPLAYPORT TO HDMI/DVI
The DisplayPort output can be converted into a HDMI or DVI output using an addional passive adapter cable. The integrated graphics automacally detects the
connected display and outputs the appropriate electric signal - either DisplayPort (without an adapter) or HDMI/DVI (with an adapter). However, a monitor with a
DisplayPort connector cannot be connected to the HDMI port with a simple passive adapter.
[6] OPTIONAL WIRELESS LAN MODULE (WLN-M)
This model supports the oponal Shule accessory WLN-M which includes a M.2 2230 card with IEEE 802.11 ac and Bluetooth 4.0 funconality and two external
antennas with appropriate antenna cables.
[7] INSTALLATION OF WINDOWS 7
The Intel® 100 chipset series no longer supports the Enhanced Host Controller Interface (EHCI), which is the driver soware for USB 2.0 ports. The new chipset only
supports the updated Extensible Host Controller Interface (xHCI for USB 3.0) which is not supported by the original Windows 7 installaon disk. This means that
peripheral devices connected by USB (like a keyboard or mouse) will not work during the Windows 7 installaon. There are two soluons that can be used: (1) use a
PS/2 keyboard or mouse and install Windows 7 from an internal DVD drive or (2) add the required USB 3.0 drivers to the Windows 7 installaon les (the steps for
this soluon can be found in the Shule FAQ secon of global.shule.com). Windows 7 is only supported if a 6th generaon Intel® Core™ processor is used.
[8] TURBO BUTTON
Please make sure the following requirements are met to enable the Turbo Buon:
1) Operang system: Windows 10
2) Intel® Core™ processor of the K series (with unlocked mulplier)
3) Install and run the Shule Overclock Tool. You will nd the latest version of this soware here
BIOS DOWNLOADS: hp://global.shule.com/products/productsDownload?productId=2235
SUPPORT LIST: hp://global.shule.com/products/productsSupportList?productId=2235
FAQ LIST: hp://global.shule.com/support/faq
PRODUCT WARRANTY: hps://us.shule.com/barebone-support/policy-xpc-barebone/
SZ270R9
[5] SIMULTANEOUS THREE DISPLAYS
The SZ270R9 supports a maximum of two displays with a DVI or HDMI input. If needed, a third digital display requires connecng directly to the DisplayPort output
(without an adapter).










