User's Manual

Page

Next Generation

Signal Enhancement

6. To Get started-Basic Software Control of the System

6.1. General

The system is equipped with a supervisory module that allows the monitoring

and control of various parameters such as RF power, attenuation,

temperature, status of door and alarm conditions etc.

The communication interface between the local terminal and the control

module can be set up using the Configuration & Monitoring Console software

(CMC), which is an easy to use GUI for simple control and monitoring. It

enables monitoring of parameters & subsequent adjustment if required.

This function can be performed either using a terminal (PC/laptop) locally, or

through remote login using the wireless modem (Optional) located in the

repeater. USB port is provisioned in the equipment for connecting PC/laptop.

6.2. Terminal Set-up

The system is delivered with software loaded in order to perform configuration

as per requirement. The laptop/PC should be loaded with the CMC software

available on the supplied CD along with the USB driver.

Functions as described below are carried out through CMC software:

I) Login Repeater (Figure 4)

After running the Configuration & Monitoring Console (CMC), user needs to

• Click the “Login” on the command bar.

• Select the user type.

• Enter the password.

• Finally click the “OK”.

After successful login, a message “Logged in successfully” will be flashed

on the screen. Now user can start the operation through CMC.

There are two types of users viz. ADMINISTRATOR and SUPERVISOR. If

user logged in as an ADMINISTRATOR, all the operation through the CMC

can be carried out. The password by default is “SHYAM”.

SUPERVISOR is allowed to perform monitoring of the status & alarms but

no change in configuration is permitted. However, the SUPERVISOR can

change password if so desired.

Administrator can limit the system access authority of the SUPERVISOR.