User's Manual

Page
All Rights Reserved Shyam Telecom Limited 21/43
Next Generation
Signal Enhancement
Figure 12: Display of Alarms
V) Communication (Figure 13)
In COMMUNICATION window user can select serial communication port
of the computer and type of connection between repeater and computer.
There are two types of connections viz. Local and Remote
a) Local Connection
In this type of connection, user computer COM Port and repeater’s
USB Port are connected directly using cable. Steps as indicated
below, are followed:
• Click the “COMM.” on the command bar to display the
COMMUNICATION window.
• Select the Connection Type as “LOCAL”
• Select the computer’s Comm. Port where the repeater is
connected.
• Click “OK”.
b) Remote Connection
In this type of connection, User communicates from/to remote location
with the repeater using wireless Modem / Cell phone.
To connect:
• Click the “COMM.” on the command bar to display the
COMMUNICATION window.