User's Manual

Page

Next Generation

Signal Enhancement

• Select the Connection Type as “REMOTE”.

• Select the computer’s Comm. Port where the wireless Modem

is connected.

• Click “OK”.

• Now click the DIALUP on the command bar to display the

DIALUP window.

• Enter / Select the repeater phone number.

• Click the “DIAL” and wait (maximum 60 seconds) for

connection.

A message “CONNECTED” will appear on the screen after the modem

Connection is established.

Click the “DISCONNECT” on the DIALUP window to disconnect

remote communication with the repeater.

Wireless Modem (Optional) is equipped inside the housing of the

repeater and it can be easily located through a sticker provided on the

same. It has a groove with SIM cardholder in which the SIM card can be

inserted for remote communication.

VI) Security (Figure 14)

The system has been incorporated with “Security” to protect the

settings and to avoid unauthorized access. It is through a Password,

which can be set/reset. Click the Password on the command bar to

display Password Setting window where administrator can change

password.

CAUTION

When the communication between repeater & PC/Laptop is in progress

through USB:

1. Do not remove cable from the USB port.

2. Do not switch off the repeater.

In case the communication is not required any more, click at EXIT before

removing cable from USB port to avoid hanging of the PC/Laptop. In case

the PC/Laptop goes in to hanging mode, it has to be restarted after

closing/switching OFF & ON the repeater.