User Manual
Table Of Contents
- 1. Document History
- 2. Disclaimer
- _
- 3. Safety Instructions and Warnings
- _
- 4. Introduction
- 5. Functional Description Of R4 Band Selective Repeater
- _
- _
- _
- _
- _
- _
- _
- _
- _
- _
- _
- 6. To Get started-Basic Software Control Of the Repeater
- 7. R4 Repeater Specifications
- 8. Installation
- The gain of repeater is set using software control through local USB serial port or optional wireless modem
- 9. System Maintenance
Next Generation
Signal Enhancement
CAUTION
Calls attention to a procedure or practice which, if not followed, may result
in personal injury, damage to the system or damage to individual
components. Do not perform any procedure preceded by a
CAUTION until described conditions are fully understood and met.
3.3. Electrostatic Sensitivity
CAUTION
ESD = ELECTROSTATIC DISCHARGE SENSITIVE DEVICE
Observe electrostatic precautionary procedures.
Semiconductor transmitters and receivers provide highly reliable
performance when operated in conformity with the intentions of their design.
However, a semiconductor may be damaged by an electrostatic charge
inadvertently imposed by careless handling.
Static electricity can be conducted to the semiconductor chip from the centre
pin of the RF input connector, and through the AC connector pins. When
unpacking and otherwise handling the Repeater, follow ESD precautionary
procedures including the use of grounded wrist straps, grounded workbench
surfaces, and grounded floor mats.
All Rights Reserved Shyam Telecom Limited Page
4/32