Instruction manual

Chapter 2 How to use the menu CVS-128
2-12 0093112802-00
7 Select the comment position with the [ ]
key or [ ] key.
8 To stop editing, press [GAIN (HF) Knob] or
[GAIN (LF) Knob].
9 After finishing the edit, press the [MENU]
key.
10 Select the [register] in the confirmation
menu.
11 Press the [MENU] key. Then, the edit is
finished.
2.15 Selection of Zoom
Set the zoom display with the display mode
([zoom (H)] or [zoom (L)].
The [Bottom], [Bottom Discrimination], [Zoom],
[[Bottom Zoom] and [Bottom Follow Zoom] are
provided. (See [1.4 Switch-over of Menu])
1 Press the [MENU] key.
2 Select [D.range] → [Zoom type]. (See [2.1
How to operate the menu])
3 Press the [ ] key.
4 Select the zoom type. (Press the [ ] key or
[ ] key)
5 Press the [MENU] key to close the menu.
For each zoom display, refer to [1.4 Switch-over
of Display mode].
2.16 Selection of NAV Display
Selection of NAV Display
The information can be displayed on the NAV
display (NAV 1, NAV2).
Caution: Requires position data from
GPS sensor.
Type of NAV Display
The following images can be displayed on the
NAV Display (NAV1, NAV2).
Simple potter Compass
Speed meter
Wpt dist dir., Time
required, Wind dir.,
Wind speed, depth,
Lat/Lon, Boat speed,
course, water temp,
Heading and XTE
Edit end
registered
Not registered
Zoom type
BTM.
Zoom
B.Z.
B.D.
B.F.Z.
1
2
3
P I C 00 00 1
P I C 00 0
02
P I C 00 003
Image comment
No. Comment
XTE
HDG
The time required
Wind dir.
Wind speed
RNG BRG
Course
Lat/Lon
Water temperature
Depth
Boat speed