Instruction manual

Chapter 5 Installation CVS-128
5-8 0093112802-00
5.4 Wiring
Connection of Cable to CVS-128 Display unit
Connect the power cable and transducer to the connectors of CVS-128 Display unit.
Pin Assignment of Rear Connector
Pin assignment viewed from the rear of CVS-128 Display unit.
Power input
10.8~31.2VDC
NMEA data input output
GPS, plotter etc
Sona-tone output
Line output for speaker with amplifier
Power output
For power of GPS etc
T
ransducer
For 50/200kHz in common
Speed sensor data input
Water temperature sensor data input
External monitor
Analog RGB
Sona-tone R
Sona-tone L
Power +
GND
NM E A T
X
-
NM E A T
X+
NM E A R
X+
NM E A R
X
-
Power -
Shield
Sona-tone COM
Outside power
Speed sensor input
Speed sensor power
Transducer input output
Transducer shield
Transducer input output
Water temperature sensor power
Water temperature sensor input
Speed sensor GND
J6
R
R-GND
G
G-GND
B
B-GND
H-SYNC
V-SYNC
Un-connected
J7
Un-connected
POWER