User's Manual

Table Of Contents

RFI341 Radio Frequency Interrogator

6. Operation

6.1 Overview of the Start-up Steps

• Start the RFI341 with the default settings (Quick start)

• Connect to the PC or HOST

• Use the Demo/Parameterisation-Software to run the device or

• Control the device by using the related command strings or

• Configure (parameterise) the RFI341 for the desired application

6.2 Factory Default Settings

The table below shows the factory setting of the RFI341. The factory default

parameters are such that the RFI341 can be put into operation immediately

or following a few minor adjustments.

The default settings of the parameters are stored permanently in the RFI341

EEPROM memory. To display the stored settings, use either the PC and

execute the “REQUEST SYSTEM SETTINGS, 1010” command as described

in the document “Telegram Listing RFI341” or the PC Software and request

the display of the system settings. To change the settings, use the software

“EDIT SYSTEM SETTINGS, 1011” command.

Operation