User manual

SE 40/125S ignition protected thruster assembly 1.0 - 2007

1. Push the propeller on to the shaft and turn until the internal spline in the propeller hub aligns with the external spline on the

propeller shaft.

2. Push the propeller onto the shaft with the track for the drivepin in an horizontal position (same direction as you set the drivepin), all

the way in. There should be almost no gap between the propeller hub and the gearhouse.

3. Place the washer (4) on the prop.shaft and then tighten the lock-nut (3) on the propeller shaft.

4. Place the zinkanode (2) in its designated position and tighten the zincanode holding screw (1). Apply a thread glue (Locktite or

similar) to ensure that the zincanode holding screw does not un-screw itself from the propellers rotation.

Parts description:

1 : Screw for zincanode

2 : Zincanode

3 : Propeller lock nut

4 : Washer

Fitting propellers

Fig. 1

Locktite