Operation Manual

24
As standard, the camera image is
only displayed in the work area
during an active door call or speech
connection.
Tap to change the display and
enlarge the camera image.
The image size is set using the
Settings> Video image> Change
display modes menu:
• Standard1
The camera image appears in the
work area of the display. On the
right-hand side, the functions
“Switch light”, “Switch micro-
phone” and “Save image” are avail-
able as standard.
10:1020.05.2013
• Standard2
The camera picture is enlarged to
the top and bottom of the screen.
On the right-hand side, the func-
tions “Switch light”, “Switch
microphone” and “Save image” are
available as standard.
Display mode
Switching the ring tone off and
back on again
1
Tap the “Ring tone” symbol.
The Ring tone menu is displayed.
2 Switch the ring tone off:
• Tap “Off” to mute the panel for an
undened time.
Or
• Select how long you wish the
panel to remain muted (max.
9hours, 59minutes), and tap “Time
controlled off”.
3 Switch the ring tone back on:
Tap “On”.
Remarks
• The muting status is indicated by a
line through the symbol “Ring tone”
in the display.
• If a visitor rings the door bell or
another user rings while the panel is
muted, the speech button ashes.
Setting the ring tone and ring
tone volume
Set the ring tone and ring tone
volume under Settings > Audio
settings.
You can select between 11ring
tones, for example using a different
ring tone for the front door bell or
apartment door bell than for internal
or group calls.
The ring tone volume can be set in
5steps.
1 Open the menu Settings> Audio
settings and select the call type
such as door call1.
You will hear the current ring tone
being played.
2 Set the ring tone:
Select a different ring tone.
The selected ring tone is played.
3 If applicable, set the ring tone
volume.
Note
The set ring tone volume applies to
all calls.
Ring tone and
ring tone volume
Insert the SD card
1 Open the Settings>
Installation> SD card menu.
You will be asked to insert the SD
card.
2 Insert the SD card into the pro-
vided card slot; the bevelled corner
of the SD card is pointing upwards,
the contacts are at the back.
3 Tap “OK”.
Remarks
• Once you have inserted the SD
card, the data will be written out of
the video memory onto the SD card.
• Do NOT remove the SD card
during the write and read process.
• If the SD card is not recognized or
cannot be read, this will be indicated
in the display by a symbol (in the
status bar) and by a message (in the
Settings> Installation> SD card)
menu.
The following error mes-
sages are possible for the SD
card:
• SDcard not initialized
Format the SDcard.
• SDcard read/write error
Remove the SDcard and insert it
again.
• SDcard write protected
Remove the SDcard, remove the
write protection and insert it again.
• Unable to format the SDcard
Remove the SDcard and use a dif-
ferent one.
• SDcard defective/ unreadable
Remove the SDcard and use a dif-
ferent one.
SD card