User's Manual
Table Of Contents
- Table of Contents
- SITRANS LR250 Overview
- Specifications
- Installation
- Wiring
- Operating via the handheld programmer
- Operating via SIMATIC PDM
- Functions in SIMATIC PDM
- Quick Start Wizard via SIMATIC PDM
- Changing parameter settings using SIMATIC PDM
- Parameters accessed via pull-down menus
- Operating via AMS Device Manager
- Functions in AMS Device Manager
- Features of AMS Device Manager
- Device Description (DD)
- Configuring a new device
- Startup
- Pull-down menu access
- Device configuration
- Quick Start Wizard via AMS Device Manager
- Maintenance and Diagnostics
- Remaining Device Lifetime [see Remaining Device Lifetime (4.2.) on page 99]
- Remaining Sensor Lifetime [see Remaining Sensor Lifetime (4.3.) on page 102]
- Service Schedule [see Service Schedule (4.4.) on page 105]
- Calibration Schedule [see Calibration Schedule (4.5.) on page 108]
- Electronic Temperature
- Wear (see Wear on page 56)
- Communication
- Security
- Device Diagnostics
- AMS Menu Structure
- Functions in AMS Device Manager
- Parameter Reference
- 1. Quick Start
- 2. Setup
- 3. Diagnostics
- 4. Service
- 5. Communication
- 6. Security
- 7. Language
- Appendix A: Alphabetical Parameter List
- Appendix B: Troubleshooting
- Appendix C: Maintenance
- Appendix D: Technical Reference
- Principles of Operation
- Echo Processing
- Analog Output
- Maximum Process Temperature Chart
- Process Pressure/Temperature derating curves
- Loop power
- Appendix E: Application Examples
- Appendix F: HART Communications
- Appendix G: ATEX Certificates
- Appendix H: Firmware Revision History
- Glossary
- Index
- LCD menu structure
7ML19985JE03 SITRANS LR250 (HART) – INSTRUCTION MANUAL Page 13
mmmmm
Specifications
Threaded Horn dimensions
Threaded Connection Markings
Threaded connection markings are found on the flat face/faces of the process
connection.
Serial number:a unique number allotted to each process connection, including the date of
manufacture (MMDDYY) followed by a number from 001 to 999.
Nominal Horn Size Horn O.D.
Horn
Height to sensor
reference point
a)
a)
Height from bottom of horn to sensor reference point as shown: see
Threaded
Horn Antenna with extension
on page 12.
Beam Angle
b)
b)
– 3dB in the direction of the polarization axis (see
Polarization reference point
on page 22 for an illustration).
Measurement
Range
40 mm (1.5") 39.8 mm (1.57”) A 135 mm (5.3") 19 degrees 10 m (32.8 ft)
50 mm (2”) 47.8 mm (1.88”) B 166 mm (6.55”) 15 degrees
20 m (65.6 ft)80 mm (3”) 74.8 mm (2.94”) C 199 mm (7.85”) 10 degrees
100 mm (4”) 94.8 mm (3.73”) D 254 mm (10”) 8 degrees