User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Viewing Available Subscriber Units 91
2. Click Delete. A confirmation dialog box appears.
3. Click OK. RUGGEDCOM SAS-GW begins de-registering the subscriber unit from the SAS and removing it from
the configuration. Allow a few minutes for the process to complete.
Section4.5.7
Viewing Available Subscriber Units
There are two methods to view a list of available subscriber units.
• Method 1
The simplest method is to left-click a base station on the map. The table below the map under Base Station
then populates with information about each subscriber unit connected to the base station.
Figure72:List of Subscriber Units under Map
• Method 2
1. Point to Setup and then click All BS. The View All Base Stations screen appears.
Figure73:View All Base Stations Screen
2. Click the name of the desired base station. The screen transitions to display a summary of the connected
subscriber units.