User's Guide

Table Of Contents
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
92 Viewing Available Subscriber Units
Figure74:CPEs of BS Screen
The table in both cases displays the following information for each base station:
Column Description
CPE Name The name assigned to the subscriber unit.
State The subscriber unit's current state.
Operational – The subscriber unit is connected and in full operation
Unreachable – The subscriber unit is not responding to queries
Connected – The subscriber unit is connected, but not transmitting
NA – The default value of new subscriber units that have not been configured yet in RUGGEDCOM SAS-
GW
SAS Status The subscriber unit's current status with the SAS.
registered
granted – The SAS granted the last spectrum request
granted_failed – The SAS denied the last spectrum request
hb_ok – The SAS is operating normally
hb_failed – The SAS is not in operation
relinquished – The SAS accepted the last relinquish request
relinquished_failed – The SAS denied the last relinquish request
unregistered – The device is not registered with the SAS
register_failed – The SAS denied the last registration request
configuration_error – An error has been detected in the SAS's configuration
DL CINR The Carrier to Interference + Noise Ratio (CINR) threshold for downlink measured in decibels (dB).
UL CINR The Carrier to Interference + Noise Ratio (CINR) threshold for uplink measured in decibels (dB).
DL RSUI The Received Signal Strength Indication (RSUI) for downlink measured in decibels (dB).
Link Uptime The total time the subscriber unit has been connected with a satellite. Time is displayed in hours,
minutes and seconds (i.e. HH:MM:SU).