User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 5
Monitoring RUGGEDCOM SAS-GW
Viewing the System Log 93
Monitoring RUGGEDCOM SAS-
GW
This section describes how to monitor the status of RUGGEDCOM SAS-GW, including the individual status of
devices and the SAS server.
CONTENTS
• Section5.1, “Viewing the System Log”
• Section5.2, “Viewing the Error Log”
• Section5.3, “Monitoring SAS Alerts”
• Section5.4, “Monitoring SAS Activity”
• Section5.5, “Tracked Events”
Section5.1
Viewing the System Log
The system log details specific events that have taken place during operation.
Displaying Events
To display system events in the log, point to Reports and then click System Log. The View All System Events
screen appears.