User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 5
Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
94 Viewing the System Log
Figure75:View All System Events Screen
The table displays the following information for each log entry:
Column Description
Time The exact time and date at which the event occurred. Time is displayed in the form of YYYY-MM-DD HH-
MM-SS.
CBSD Type The type of device associated with the event.
CBSD Name The name of the device associated with the event.
Event A description of the event that occurred. For more information about each possible event, refer to
Section5.5, “Tracked Events” .
Filtering Events
Only events that occurred during the defined time period are displayed. To widen or narrow the search, do the
following:
NOTE
The date and time must be entered in the form of YYYY-MM-DD HH-MM-SS.
1. Under Start Time, enter the date and time at which to start the search. Clicking in the box will display the
calendar tool. The date and time can be selected from the tool or entered manually.