User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 5
Monitoring RUGGEDCOM SAS-GW
Viewing the Error Log 95
4
3
5
1
3
2
4
Figure76:Filtering the System Events
1.Start Date Box 2.End Date Box 3.Month/Date Selector 4.Time Selector 5.Filter Button
2. Under Stop Time, enter the date and time at which to end the search. Clicking in the box will display the
calendar tool. The date and time can be selected from the tool or entered manually.
3. Click Filter. Events that occurred during the defined time period, if any, are displayed.
Section5.2
Viewing the Error Log
The error log records the history of errors that occurred for each base station and subscriber unit managed by
RUGGEDCOM SAS-GW.
Displaying Errors
To display errors in the log, point to Reports and then click Error Log. The Error Log screen appears.