User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 5
Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
96 Viewing the Error Log
Figure77:Error Log Screen
The table displays the following information for each log entry:
Column Description
Time The exact time and date at which the error occurred. Time is displayed in the form of YYYY-MM-DD HH-
MM-SS.
Severity The severity rate assigned to the event.
Description A brief description that identifies the related device and the error that occurred.
Filtering Errors
Only errors that occurred during the defined time period are displayed. To widen or narrow the search, do the
following:
NOTE
The date and time must be entered in the form of YYYY-MM-DD HH-MM-SS.
1. Under Start Time, enter the date and time at which to start the search. Clicking in the box will display the
calendar tool. The date and time can be selected from the tool or entered manually.