User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 5
Monitoring RUGGEDCOM SAS-GW
Monitoring SAS Alerts 97
4
3
5
1
3
2
4
Figure78:Filtering the Error Log
1.Start Date Box 2.End Date Box 3.Month/Date Selector 4.Time Selector 5.Filter Button
2. Under Stop Time, enter the date and time at which to end the search. Clicking in the box will display the
calendar tool. The date and time can be selected from the tool or entered manually.
3. Click Filter. Errors that occurred during the defined time period, if any, are displayed.
Section5.3
Monitoring SAS Alerts
RUGGEDCOM SAS-GW monitors five specific alerts that may be broadcast by the SAS and displays them on the
main screen under the SAS Alerts Table.