User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 5
Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
98 Monitoring SAS Alerts
1
2
3
4
Figure79:Main User Interface
1.Toolbar 2.Interactive Map 3.Base Station Table 4.SAS Alerts Table
Tracked Alerts
Tracked alerts include:
• SAS Down
The SAS server is offline.
• Spectrum Relinquish
The SAS has requested all devices to relinquish a specific spectrum.
• BS Grant Refused or Failed
The SAS has refused or failed to grant spectrum to the base station.
• SS Grant Refused or Failed
The SAS has refused or failed to grant spectrum to the subscriber unit.
• SS Not Configured
The subscriber unit is detected, but not configured in RUGGEDCOM SAS-GW.
Monitoring Alerts
To monitor the alerts broadcast by the SAS, launch RUGGEDCOM SAS-GW and click Active SAS Launch at the top
of the main screen. The browser automatically scrolls down to the SAS Alerts table.