User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 5
Monitoring RUGGEDCOM SAS-GW
Monitoring SAS Activity 99
Figure80:SAS Alerts Table
This table displays the following information for each alert:
Column Description
Alert Name The name of the alert.
State The current state of the alert.
Last Event Time The time at which the last event occurred.
Note A list of devices involved in the event.
Acknowledge Displays a link if an event is active. Click clear to acknowledge the alert.
Section5.4
Monitoring SAS Activity
The SAS Activity log records all communications between RUGGEDCOM SAS-GW and the SAS on a device-by-device
basis. Use this log to track messages sent to the SAS and the SAS's response.
Displaying Events
To display SAS-related events, point to Reports and then click CBSD Activity. The View All SAS Activity screen
appears.