User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 5
Monitoring RUGGEDCOM SAS-GW
Tracked Events 101
4
3
7
1
5
2
6
Figure82:Filtering the SAS Events
1.Start Date Box 2.End Date Box 3.Select CBSD Type List 4.Select CBSD Name List 5.Month/Date Selector 6.Time
Selector 7.Filter Button
2. Under Stop Time, enter the date and time at which to end the search. Clicking in the box will display the
calendar tool. The date and time can be selected from the tool or entered manually.
3. [Optional] Under Select CBSD Type, select one of the following options:
• All – Displays results for all base stations and subscriber units
• BS – Displays results for only base stations
• CPE – Displays results for only subscriber units
4. [Optional] Under Select CBSD Name, enter a full or partial name of a base station or subscriber unit. Entries
that fully or partially match are displayed.
The default value is All.
5. Click Filter. Events that occurred during the defined time period, if any, are displayed.
Section5.5
Tracked Events
RUGGEDCOM SAS-GW tracks the following events during operation.
NOTE
Each event can be communicated via SMS alerts to individual users. For more information, refer to
Section4.3.4, “Configuring SMS Alerts” .