User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 5
Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
102 Tracked Events
User Events
Event Description
New user was added to database A new user was added to RUGGEDCOM SAS-GW.
User was deleted from database A user was deleted from RUGGEDCOM SAS-GW.
Subscriber Unit Events
Event Description
SU is inaccessible The subscriber unit is either offline or its associated base station is not transmitting.
SU TX turned on The subscriber unit has started transmitting.
New SU was added to database A new subscriber unit has been added to the RUGGEDCOM SAS-GW configuration.
New SU was deleted from database A subscriber unit has been removed from the RUGGEDCOM SAS-GW configuration.
SU Grant refused or failed The SAS has refused or failed to grant spectrum to the subscriber unit.
SU not configured The subscriber unit is detected, but not configured in RUGGEDCOM SAS-GW.
Base Station Events
Event Description
BS is inaccessible The base station is offline.
BS is accessible and TX OFF The base station is online but not transmitting.
BS TX turned on The base station has started transmitting.
New BS was added to database A new base station has been added to the RUGGEDCOM SAS-GW configuration.
New BS was deleted from database A base station has been removed from the RUGGEDCOM SAS-GW configuration.
BS mode is Answer Positive. Tx stays open. Manual Operation has been set to Answer Positive for the base station. The base
station continues to transmit.
BS mode is Answer Negative. Tx stays open. Manual Operation has been set to Answer Negative for the base station. The base
station continues to transmit.
BS Grant refused or failed The SAS has refused or failed to grant spectrum to the base station.
SAS Events
Event Description
SAS server down The SAS server is offline.
SAS requested spectrum relinquish. Sector is
going down.
The SAS has requested all devices to relinquish a specific spectrum.
Database connection lost The SAS database is offline.
CBSD configuration problem An error is detected in the configuration of the SAS.
CBSD was deleted upon user request A device is removed from RUGGEDCOM SAS-GW by a user.
CBSD Frequency has been changed The spectrum frequency range for a device has changed.