User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 1
Introduction
RUGGEDCOM SAS-GW
User Guide
6 Supported RUGGEDCOM WIN Devices
SAS-GW uses the Simple Network Management Protocol (SNMP) to monitor the status of the SAS server and the
device.
Should the device stop responding, the associated spectrum will be released back to the SAS server.
Should the SAS server stop responding, the device will be allowed to continue transmitting on the assigned
spectrum.
Section1.4
Supported RUGGEDCOM WIN Devices
RUGGEDCOM SAS-GW is required by the following RUGGEDCOM WIN devices when operating in the United States
within the 3.5 GHz band:
Base Stations RUGGEDCOM WIN7237
Subscriber Units RUGGEDCOM WIN5137
RUGGEDCOM WIN5137-V
RUGGEDCOM WIN5137-V-GPS
RUGGEDCOM WIN5237
Section1.5
Licensing and Copyright
Licensing and copyright information specific to RUGGEDCOM SAS-GW v1.2 is available on the About screen.
To view licensing and copyright information, point to Setup and then click About.