User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 2
Installation and Deployment
RUGGEDCOM SAS-GW
User Guide
10 Installing RUGGEDCOM SAS-GW
Server Side
Operating Environment
• Linux PC or Virtual Machine
Operating System
• Ubuntu Server LTS v14
Hardware
• CPU: 1 GHz processor (e.g. Intel Celeron or better)
• RAM: 1.5 GB
• Available Memory: 7 GB
Section2.2
Installing RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW runs on Ubuntu Server, which can be installed on a Personal Computer (PC) or virtual
machine.
IMPORTANT!
RUGGEDCOM SAS-GW strongly recommends installing the RUGGEDCOM SAS-GW server in a
Demiltarized Zone (DMZ).
To install RUGGEDCOM SAS-GW, do the following:
NOTE
Improve the performance of RUGGEDCOM SAS-GW by configuring a remote database for Ubuntu. For
more information, contact Siemens Customer Support.
1. Install Ubuntu Server LTS v14 on a PC or virtual machine. During the installation, do the following:
• When asked how to manage updates, select No automatic updates. Automatic updates are not
recommended.
• Install OpenSSH server.
• Install LAMP server.
• Install the GRUB boot loader to the master boot record.
2. Launch an SSH client and connect to the PC using the following connection settings:
Host Name The IP address of the PC. This can also be prefixed with the desired user profile (e.g.
admin@192.168.0.2).
Port 22
3. If the device's SSH key has not been cached to the PC's registry, a confirmation message will appear asking if
the host is trusted. Click Yes to continue. The login prompt appears.
login as:
4. Enter the name of the root user.
5. Enter the root user's password.
The following prompt appears:
{user}@{hostname}:~$
6. Copy the RUGGEDCOM SAS-GW installation file (SAS.gz) to the user's directory under /home (e.g. /home/
admin).
7. Extract the following files from the installation file: SAS.tar and install.sh