User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 2
Installation and Deployment
Connecting to the SAS 11
8. At the command prompt, enter:
Sudo ./install.sh
9. When prompted, enter the root user's name and password.
The installation begins. When completed, the following message is displayed:
Installation completed
10. If the RUGGEDCOM SAS-GW server resides in a different time zone than the SAS, configure the local time
zone. For more information, refer to Section4.1, “Configuring the Local Time Zone” .
11. Configure the connection between RUGGEDCOM SAS-GW and the SAS. For more information, refer to
Section2.3, “Connecting to the SAS” .
12. [Optional] Enable SMS alerts via the programmable SMS service offered by Twilio [https://www.twilio.com].
For more information, refer to Section2.4, “Enabling SMS Alerts” .
13. Add base stations and subscriber units to RUGGEDCOM SAS-GW. For more information, refer to Section2.5,
“Deploying a RUGGEDCOM SAS-GW Network” .
Section2.3
Connecting to the SAS
To configure the connection between RUGGEDCOM SAS-GW and the SAS, do the following:
NOTE
If the connection to the SAS server is lost, all devices granted spectrum will be permitted to continue
operating while the connection is restored.
NOTE
All information should be available from the SAS provider.
1. Point to Setup and then click Settings. The Update System Configuration screen appears.