User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 2
Installation and Deployment
RUGGEDCOM SAS-GW
User Guide
14 Enabling SMS Alerts
1
23
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
1819
20
21
22
Figure4:Update System Configuration Screen
1.Map Refresh Interval Box 2.SNMPv2 Read Community Box 3.SNMPv2 Write Community Box 4.Map Source List 5.Proxy
Operational Status Box 6.User ID Box 7.FCC ID Box 8.CBSD Manufacturer Box 9.Call Sign Box 10.Radio Technology Box
11.Supported Specification Box 12.Sensing Capability Box 13.Twilio SID Box 14.Twilio Token Box 15.Twilio Phone Number
Box 16.Time Zone List 17.Manual Operation List 18.SAS URL Box 19.SAS Device Certificate Box 20.SAS Device Key Box
21.SAS CA Certificate Box 22.Sector Down Upon SU Box 23.Apply Button
4. Configure the following parameters: