User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 2
Installation and Deployment
Deploying a RUGGEDCOM SAS-GW Network 15
Parameter Description
Twilio SID The SMS API's application SID (Security Identifier).
Twilio Token The access token used by the SMS API for authentication.
Twilio Phone Number The phone number used by the API to send SMS alerts.
5. Click Apply.
6. Configure SMS alerts for individual users. For more information, refer to Section4.3.4, “Configuring SMS
Alerts” .
Section2.5
Deploying a RUGGEDCOM SAS-GW Network
To deploy RUGGEDCOM SAS-GW with RUGGEDCOM WIN devices as part of a complete 3.5 GHz network, do the
following:
1. Deploy the required base stations fully configured, making sure all radio transmissions are disabled.
2. Deploy the required subscriber units fully configured. Subscriber units will not transmit until their associated
base station transmits.
3. Add each subscriber unit to RUGGEDCOM SAS-GW. For more information, refer to Section4.5.1, “Adding a
Subscriber Unit”
NOTE
Subscriber unit's are not accessible through RUGGEDCOM SAS-GW until spectrum is granted to
their associated base station.
RUGGEDCOM SAS-GW automatically registers each subscriber unit with the SAS and requests spectrum. When
spectrum is granted, the subscribber station's operational status in RUGGEDCOM SAS-GW is updated to:
Granted | not accessible
For information about looking up the operational state of a subscriber unit, refer to Section3.4, “Determining
the Status of Base Stations and Subscriber Units” .
4. Add each base station to RUGGEDCOM SAS-GW. For more information, refer to Section4.4.1, “Adding a Base
Station”
RUGGEDCOM SAS-GW automatically registers each base station with the SAS and requests spectrum. When
spectrum is granted, the base station will automatically start transmitting. Subscriber units will also start
connecting to the base station.