User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 3
Using RUGGEDCOM SAS-GW
Logging In 17
Using RUGGEDCOM SAS-GW
This chapter describes how to use RUGGEDCOM SAS-GW, including how to use the Web user interface, view
reports and enable Troubleshooting mode.
NOTE
The configuration of base stations, subscribers stations and users is described in Chapter4,
Configuring RUGGEDCOM SAS-GW .
CONTENTS
• Section3.1, “Logging In”
• Section3.2, “Logging Out”
• Section3.3, “Using the Interface”
• Section3.4, “Determining the Status of Base Stations and Subscriber Units”
• Section3.5, “Accessing a Station's Interface”
• Section3.6, “Determining the Current Version Installed”
• Section3.7, “Enabling/Disabling Troubleshooting Mode”
• Section3.8, “Configuring the Map”
Section3.1
Logging In
To log in to RUGGEDCOM SAS-GW, do the following:
1. Launch a Web browser and request a connection to the RUGGEDCOM SAS-GW workstation. The LogIn screen
appears.