User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 3
Using RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
18 Logging Out
2
1
3
4
Figure5:LogIn Screen
1.Username Box 2.Password Box 3.Submit Button 4.Remember Me Check Box
2. Under Username, enter a user name.
3. Under Password, enter the password associated with the user name.
4. [Optional] Select Remember Me?. The user name and password will be retained for subsequent sessions until
changed.
5. Click Submit.
Section3.2
Logging Out
To log out of RUGGEDCOM SAS-GW, point to User and then click Logout.
Section3.3
Using the Interface
The RUGGEDCOM SAS-GW Web user interface is designed to put all essential information at the forefront to allow
users to quickly asses the status of their 3.5 GHz band network. The main screen includes the following features:
• Toolbar
The toolbar provides access to configuration settings, reports and user information.
• Interactive Map
The map displays the physical location of all base stations and their associated subscriber units.
• Base Station Table
The Base Station table displays important information about any base station selected from the map.
• SAS Alerts Table
The SAS Alerts table displays the current state of alerts broadcast by the SAS.