User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 3
Using RUGGEDCOM SAS-GW
Menus 19
1
2
3
4
Figure6:Main User Interface
1.Toolbar 2.Interactive Map 3.Base Station Table 4.SAS Alerts Table
CONTENTS
• Section3.3.1, “Menus”
• Section3.3.2, “Help Text”
• Section3.3.3, “Using the Map”
Section3.3.1
Menus
The top toolbar features the following menus that provide access to important functions and reports.
Setup
Menu Item Description
Add BS Adds a new base station to the RUGGEDCOM SAS-GW configuration.
Add SU Adds a new subscriber unit to the RUGGEDCOM SAS-GW configuration.
All BS Displays a list of all base stations.
Settings Displays the general settings for RUGGEDCOM SAS-GW.