User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 3
Using RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
22 Accessing a Station's Interface
Device Status Base Station Subscriber Unit
Pending request
Maximum power not approved
Not operational
Users can also left-click the icon to display a pop-up. The pop-up indicates the base station or subscriber
unit's current operating state (e.g. operational, unreachable, etc.) and its status with the SAS (e.g. granted,
unregistered, etc.).
1
2
Figure9:Pop-Up (Example)
1.Operating State 2.SAS State
Section3.5
Accessing a Station's Interface
The base station or subscriber unit's user interface can be opened directly from the RUGGEDCOM SAS-GW map. To
access the user interface for a device, do the following:
IMPORTANT!
Base station interfaces are only accessible when the base station is transmitting. Similarly, subscriber
unit interfaces are only accessible when the associated base station is transmitting.
1. Left-click the base station or subscriber unit on the map. A pop-up dialog box appears.