User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 3
Using RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
24 Enabling/Disabling Troubleshooting Mode
1
Figure11:About WIN RUGGEDCOM SAS-GW Screen
1.Product Version
The Product Version box indicates the current version.
Section3.7
Enabling/Disabling Troubleshooting Mode
When needed, RUGGEDCOM SAS-GW can be put into troubleshooting mode either for evaluation purposes or
under debugging conditions. In this mode, SAS activity is simulated and changes to the wireless network are
blocked.
To enable or disable troubleshooting mode, do the following:
1. Point to Setup and then click Settings. The Update System Configuration screen appears.