User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Configuring the Local Time Zone 31
Configuring RUGGEDCOM SAS-
GW
This chapter describes how to configure user profiles, base stations and subscriber units in RUGGEDCOM SAS-GW.
CONTENTS
• Section4.1, “Configuring the Local Time Zone”
• Section4.2, “Configuring the SNMP Read/Write Communities”
• Section4.3, “Managing User Accounts”
• Section4.4, “Managing Base Stations”
• Section4.5, “Managing Subscriber Units”
Section4.1
Configuring the Local Time Zone
The time zone where the RUGGEDCOM SAS-GW server resides must be defined if the SAS is in a different time
zone. Log entries are timestamped with the current time zone and the current time provided by the server.
To specify the local time zone where the base stations and subscriber stations managed by RUGGEDCOM SAS-GW
reside, do the following:
1. Point to Setup and then click Settings. The Update System Configuration screen appears.