User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Managing User Accounts 35
Parameter Description
SNMPv2 Read Community Synopsis: A string
Default: public
The name of the SNMP read community.
The community name must match the name used by all registered base stations
and subscriber units.
SNMPv2 Write Community Synopsis: A string
Default: private
The name of the SNMP write community.
The community name must match the name used by all registered base stations
and subscriber units.
3. Click Apply.
Section4.3
Managing User Accounts
This section describes how to configure and manage user accounts in RUGGEDCOM SAS-GW.
IMPORTANT!
User accounts can only be added or updated by admin users.
CONTENTS
• Section4.3.1, “Adding a User Account”
• Section4.3.2, “Updating a User Account”
• Section4.3.3, “Changing User Password”
• Section4.3.4, “Configuring SMS Alerts”
• Section4.3.5, “Removing a User Account”
• Section4.3.6, “Listing User Accounts”
Section4.3.1
Adding a User Account
To add a new user account, do the following:
1. Point to User and click Add User. The Register New User screen appears.