User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
Chapter 4
Configuring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
36 Adding a User Account
1
2
3
4
5
6
7
8
Figure17:Add User Screen
1.User Name Box 2.Password Box 3.Re-Type Password Box 4.E-Mail Box 5.First Name Box 6.Last Name Box 7.Phone
Box 8.Register Button
2. Configure the following parameters:
Parameter Description
User Name Synopsis: A string 5 to 25 characters long
A unique name used by the user to log in to RUGGEDCOM SAS-GW.
Password Synopsis: A string 8 to 50 characters long
The password used by the user to log in to RUGGEDCOM SAS-GW.
Re-Type Password The password used by the user to log in to RUGGEDCOM SAS-GW.
3. [Optional] Configure these additional parameters to define the user's contact information:
Parameter Description
E-Mail The user's e-mail address.
First Name The user's first name.
Last Name The user's last name.
Phone The user's phone number. This is required for the user to receive SMS alerts.
4. Click Register.