User's Guide
Table Of Contents
- RUGGEDCOM SAS-GW
- Table of Contents
- Preface
- 1. Introduction
- 2. Installation and Deployment
- 3. Using RUGGEDCOM SAS-GW
- 4. Configuring RUGGEDCOM SAS-GW
- 4.1. Configuring the Local Time Zone
- 4.2. Configuring the SNMP Read/Write Communities
- 4.3. Managing User Accounts
- 4.4. Managing Base Stations
- 4.4.1. Adding a Base Station
- 4.4.2. Updating a Base Station's Configuration
- 4.4.3. Updating a Base Station's Location
- 4.4.4. Updating a Base Station's Antenna Characteristics
- 4.4.5. Updating SNMP Settings
- 4.4.6. Updating CPI Information
- 4.4.7. Removing a Base Station
- 4.4.8. Viewing Available Base Stations
- 4.4.9. Viewing the Measurements Report
- 4.4.10. Viewing the SAS Registration Information
- 4.5. Managing Subscriber Units
- 5. Monitoring RUGGEDCOM SAS-GW
RUGGEDCOM SAS-GW
User Guide
Chapter 4
Configuring RUGGEDCOM SAS-GW
Updating a User Account 37
Section4.3.2
Updating a User Account
To change a user's account settings, do the following:
Updating the Current User's Account
1. Point to Users and then click My Account. The Update My Account screen appears.
1
2
3
4
5
6
Figure18:Update My Account Screen
1.User Name Box 2.First Name Box 3.Last Name Box 4.Phone Box 5.E-Mail Box 6.Apply Button
2. Configure the following parameters:
Parameter Description
First Name The user's first name.
Last Name The user's last name.
Phone The user's phone number. This is required for the user to receive SMS alerts.
E-Mail The user's e-mail address.
3. Click Apply.
Updating Another User's Account
1. Point to Users and then click All Users. The View All users screen appears.